|
Who's Online
There currently are 5778 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
1
An image is light or blurred entirely.
� Is the toner low? (Is "Toner Low" being displayed?) � Yes � No � No � Yes Supply a toner.
Is the specified paper being used? Use the specified paper. Is the lens of the LED head dirty? Clean the LED head.
� Yes � No
Is the LED head installed correctly? (Check the CN6 connector of the main control board.) � No Install the LED head correctly. Is the contact plate of the transfer roller in correct contact with the high-voltage power supply board? (See Figure 6-4 F .) Is the terminal of the EP unit in correct contact with the contact plate? (See Figure 6-4 A and B )? Contact the terminal correctly. Replace the transfer roller.
� Yes
� Yes
� No � Yes
� Has this error been recovered? � Yes � No End
Replace the EP unit.
� Has this error been recovered? � Yes End
Caution: After replacing the EP unit, reset the drum counter. (Refer to "Replacing the Drum Cartridge" in "User's Manual".)
� No Replace the main control board or high-voltage power supply board.
6 - 14
|
|
|
> |
|