Found the quality of the copy excellent and a very quick service. I would certainly recommend the service.
Text excerpt from page 160 (click to view)
Remove three screws 9 which are holding the guide R (2nd) assy 0 to the bottom plate A. Remove the screw B which is keeping the rear cover C and guide R (2nd) assy 0. Remove the guide R (2nd) assy 0. (7) Remove the protect (M) D, guide bracket E, planet gears F and planet gear bracket G. (8) Remove the E-ring H which is keeping the sheet link I on the guide R (2nd) assy 0, and pull out the hinge stand J. (9) Remove three remaining screws K which are keeping the motor on the motor bracket L, and remove the connector off the Stepping Motor M. (10) Remove two screws N on the Stepping Motor M.
Note : The guide bracket E must be attached as shown in the following illustration:
No jutting of the gear shaft G is allowed into the oval hole E. Turn
L M B E F G
E clockwise for screw C
looseness to affix firmly.
A E 9
The upper plate 3 must be attached as shown in the following illustration.